Discussion:
Carbide Cut off , Neck reduction grind and Weldon Flats on a Tradesman DC Grinder
(too old to reply)
Sailor_Jeff
2016-11-15 21:59:32 UTC
Permalink
Raw Message
I would put a picture up here but cant fiqure out how to attach it

www.tradesmangrinder.com

enjoy

Jeff
Gunner Asch
2016-11-16 04:25:52 UTC
Permalink
Raw Message
On Tue, 15 Nov 2016 13:59:32 -0800 (PST), Sailor_Jeff
Post by Sailor_Jeff
I would put a picture up here but cant fiqure out how to attach it
www.tradesmangrinder.com
enjoy
Jeff
How much are they?


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
StarDust
2016-11-24 22:02:51 UTC
Permalink
Raw Message
Post by Sailor_Jeff
I would put a picture up here but cant fiqure out how to attach it
www.tradesmangrinder.com
enjoy
Jeff
Just get a 6" diamond wheel 180 grid, use your small manual grinder to do all those tricks on carbide.
I often regrind carbide e-mills!

Loading...